Carressa Fontaine Hardwood Flooring July 28, 2019 15:34:56
The final product in the Impressions hardwood flooring line is the 3/4" thick solid hardwood floor Classic Series. The Classic Series features a Hand-scraped surface and 3 colors of oaks to choose from. The Wheat Color available in this line is an extremely popular color that is a light coloring over natural and pulls on neutral tones to look great in any room. This product is 3/4" Thick solid hardwood floor and 5" wide with all 4 sides beveled to define the board. The Classic series features a Vintage Grade white oak hardwood custom selected to reflect the old world look and rustic styling. The Classic series carries a 50 year finish warranty & lifetime structural warranty and can be installed on or above grade. Each plank in this collection is hand crafted individually and is plantation grown making this a green hardwood flooring product. The finish on this product is a water based finish called Perma-Finish, which is a commercial grade finish that shows the grain in the hardwood underneath with more vivid coloring and when scratched doesn`t show coloring from the finish. This product is milled from 1 foot to 7 foot lengths with an average board length in the 4 foot range, making this a long board product that is great for large expanses.
Finishing-Most hardwood floors are sold with some form of factory finish. These consist of protective coats of polyurethane, aluminum oxide, or a combination of both, that are applied to protect the wood from wear and tear. The latest available factory finishes have been formulated to make hardwood flooring more scratch-resistant. In case you purchased unfinished flooring, it will still need to undergo finishing once the floors are installed. However, the quality of the finishing will not be as good as if it were finished in a factory.
The Walk On method of installing hardwood flooring requires precise panel laying. This process of installing hardwood flooring waits until the glue is very tacky and then lays the panel in the glue. This keeps you from getting glue smudges all over your panels as you go. Experienced hardwood installers typically use the Walk On method because of the better finished results it can provide. Since you are reading instructions about how to install hardwood floors, we`ll assume you`re using the Wet Lay method.
If you choose the Wet Lay method for installing hardwood flooring, you`ll be putting glue across the substrate followed by placing the hardwood panel on top of the glue. After the glue starts to become tacky, you proceed to the next panel. However, sometimes it is recommended for first time installers using the glue down method to place the next panels before the glue becomes tacky so that you can adjust your panels a few minutes later if they are not lined up properly.
Aesthetics: the beauty of hardwood floors is undeniable. It is reminiscent of nature in all its glory. Wood floors can also be sanded and refinished easily to change the color of the floor should you get tired of the current look. The versatility of wood floors also makes it perfect for any kind of interior design conceivable.
The next product in the Impressions hardwood flooring line is a top selling 1/2" thick engineered hardwood called the Salem Series. The Salem series features a Perma-Finish Commercial Grade Water Based finish and is stocked with only Prime Select Grade oak products. The Salem Series has Red Oak & Brazilian Cherry as species available to the name and can be installed below, above & on grade. The Salem Series is an engineered hardwood floor with a hardwood base panel & 2mm thick sawn face wear layer for Oaks & 1.4mm for the Brazilian cherry. The Perma-Finish, being that it is a water base, allows the true coloring of the grain to show through and shine and is added protection against scratching. This product features boards of 1`-4` and an average board length of 31" making it a longer plank than most engineered wood flooring on today`s market. The edges on this product are a 4-sided micro bevel and prevent chipping at the edges while defining the edge of each board. This environmentally friendly hardwood leaves a smaller carbon footprint on the planet due to less waste & less use of domestic trees in the creation of this floor. This is a very thick engineered hardwood and may be sanded and recoated many times over the life of this floor and will last many years. This product is only available in 3" widths for both the Oaks & Brazilian cherry floor. This product can be easily installed either by Glue, Nail or Staple down. The Brazilian Cherry is Lacey Act Compliant being harvested from forests that are used solely for hardwood flooring purposes.